Product Name: CORROSION BLOCK ® Grease
Application: Corrosion Block® Grease is a high performance, high temperature, multi-purpose grease mixture.
WHMIS: This product is not controlled under WHMIS
SECTION II - HAZARDOUS COMPONENTS
Chemical Names CAS # OSHA / PEL %
Petroleum Oils and non-hazardous additives NA Not applicable 100
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: NA Specific Gravity (H2O=1): 1
Vapor Pressure (mmHg.): NA Melting Point (Deg. F): NA
Vapor Density: NA Evaporation Rate: NA
Solubility in Water: Negligible @25C° Freeze Point: NA
Appearance/Odor: Turquoise grease/fresh
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point: 455 F. Method: COC
Flammable Limits: ND
Extinguishing Media: CO², Dry Chemical, Foam, Water spray
Fire Fighting Procedures: Use full protective equipment and self-contained breathing apparatus. Cover
with extinguishing agent. Use water spray to cool fire exposed containers and as a protective screen. Do not point solid water stream directly into burning liquid to avoid spreading fire.
Combustion Products: Oxides of carbon, Sulphur, Phosphorus, Nitrogen, Hydrogen Sulfide
SECTION V - REACTIVITY DATA
Incompatibility: Oxidizing agents (Hydrogen Peroxide, Bromine, and Chronic Acid)
Hazardous Decomposition: Thermal conditions produces normal products of combustion including: Carbon Oxides (CO- C0²) Nitrogen oxides (N0²-NO) Sulfur oxides (S0²-SO3).
Phosphorous, Oxides of Calcium
Hazardous Polymerization: Will not occur
SECTION VI - TOXICOLOGICAL PROPERTIES
Primary Routes of entry:
Acute Oral: LD50: ND Acute Eye: LC50: ND
Acute Dermal: LD50: ND Acute Vapor: LC50: ND
Carcinogenicity: Non-carcinogenic, according to NTP, IARC, OSHA or ACGIH.
Mutagenic effects: No Tetragenic: No
Reproductive: No Developmental: No
NOTE: This is an untested mixture. The toxicological information is based on the most hazardous ingredient.
EFFECTS OF OVEREXPOSURE:
Skin and Eyes: May cause drying, of skin, dermatitis; May cause mild irritation of eyes
Ingestion: Low Toxicity will have laxative effect
SECTION VII - EMERGENCY AND FIRST AID PROCEDURES
Skin: Remove excess by wiping, followed by washing with soap and water.
Eyes: Copious warm water flush - 15 minutes, Physician assessment if eyes inflamed.
Inhalation: Evacuate to fresh air. Apply CPR if required. If resuscitation is required, Physician assessment mandatory.
Ingestion: DO NOT INDUCE VOMITING. If vomiting takes place, naturally, lean victim forward to prevent aspiration into lungs. Aspiration into the lungs may cause chemical pneumontis, which can be fatal. Mandatory physician assessment : Note to Physician: Consult standard literature for Hydrocarbon poison.
SECTION VII - PREVENTIVE MEASURES
Steps to be taken if Spilled: Using dry clay, commercial sorbents, collect residue into suitable container for disposal.
Waste Disposal Method: Dispose in approved landfill site or incinerate at licensed waste reclaimer facility. Follow all Local, Provincial, State and Federal Requirements. Materials not listed as a hazardous waste under RCRA.
Ventilation: None normally needed.
Respiratory Protection: None normally needed
Protective Gloves: None normally needed.
Eye Protection: None normally needed.
Other Protective Clothing: None normally needed.
Work/Hygienic Practices: Wash hands and face with soap and water after use. Launder soiled clothing.
SECTION X - REGULATORY INFORMATION
U.S. Federal Regulations: Not Regulated by TDGR
TSCA Inventory. Not Reported/Not Included
SARA Extreme Hazard: NO
SARA Toxic Chemical: NO
TITLE III Hazard Classification Section 311, 312:
Fire: No Chronic: No Pressure: No .
Reactivity: No Acute: No